Water supply work

Copper pipe repairs

Copper is the backbone of Sydney's older water plumbing, and it fails in recognisable ways: pinholes where decades of internal erosion thinned the wall, splits where water hammer found a weak point, and joints let down by old soldering. A proper repair cuts back to sound metal and rebuilds the section, it never bandages decay.

Scope

What this covers

  • Cutting out split or pinholed lengths back to clean material

  • New joints made by silver brazing or press-fit connection

  • Replacing work-hardened bends and repeatedly repaired segments

  • Re-clipping pipework so movement stops stressing the repair

Timing

When it's needed

A green-stained wall, drummy plaster along a pipe run, repeated pinholes in one line, or a bang inside a wall followed by a hiss. Several failures along the same run usually argue for resectioning instead of a third spot fix.

Never step into standing water in a room where the power is still on, and stay from under any ceiling sagging with the weight of water. If the supply cannot be isolated and water is approaching the switchboard, keep everyone clear and treat the situation as an electrical emergency first and a plumbing problem second.

Quote variables

What shapes the scope

Repairing water supply pipework in NSW is licensed plumbing work regulated through NSW Fair Trading under the Home Building Act. Whoever repairs a burst must hold a current plumbing licence, ask to see it, and certifiable work should come with a compliance certificate on completion.

Repair work

Start your quote

Send through the job details and we'll connect you with a licensed provider who can quote this work.

If this is an emergency or anyone is at immediate risk, contact the relevant emergency service or your network or utility operator directly instead of using this form.